These mounts are designed specifically to fit the main circuit board of the JETI DSM 10 Switch. These mounts are fabricated from a durable, UV resistant plastic, and feature vibration dampening "feet". Available in ORANGE and GRAY.
TBOLT JETI DSM 10 JETI Mounts include a base, cover, and QTY 2 mounting screws. (Please note: JETI DSM 10 Switch sold separately.
Split and align the JETI DSM 10 switch power wires (side with just the black & red wires labelled "OUT" on the JETI DSM 10) between the base post on the back of the TBOLT Mounting base.
Slide the JETI DSM 10 circuit board into the base (the edges of the JETI DSM 10 circuit board fit inside channels on either side of the inside of the base.
Fully Slide the JETI DSM 10 Switch circuit board into the base (The switch should be completely inside the base).
Align mount cover so that the small pins on the back side of the cover fits inside of the mount base slots (on the opposite side of the JETI DSM 10 Power Wires (OUT side).
Carefully slide the pins of the cover into the slots of the Mount base. .
Make sure the mounting "feet" towers on the cover align with the mounting "feet" on the base. Snap the back side of cover over the edge of the base.
Use the included screws to fasten the mount to your aircraft.