Categories

ULTRA IBEC HV - Ignition Battery Eliminator Circuit and Kill Switch

  • Shipping Weight: 0.2lbs

$79.99CDN  $62.17CDN
Save: 22% off

Add to Cart:
This is the "NEW" High Voltage version of the Ultra IBEC. This version still supports an output of 5.9Volts - which works with 99% of all "old" ignition modules.
 

Eliminates the need for a separate ignition battery and mechanical on/off switch.

 
Compatible with the power requirements of single and multi-cylinder model CDI ignition modules via jumper selectable 5.9V, 6.3V, 7.3V and 8V voltage outputs.
 
Enhanced flexibility and safety via transmitter control of CDI ignition power from a receiver auxiliary channel.
 
Tech-Aero exclusive 4 stage filtering removes interference from CDI ignition noise in the wiring path to the receiver, permitting use with 2.4 GHz Spread Spectrum and 72 MHz FM radio receivers.
 
Filter stages 1 & 2: An advanced 2nd order common mode LC power lead filter.
 
Filter stage 3: Triple power filter capacitors form a low pass filter and enhance peak impulse current delivery to the CDI module.
 
Filter stage 4: An optical isolator circuit prevents any stray noise from feeding back into sensitive receiver electronics via the signal lead.
 
A high precision, low dropout power regulator design further assures power receiver bus isolation with superior performance during peak current.
 
One IBEC model fits all: compatible with any battery technology commonly used for radio control use, with a usable input voltage range from 4.8V to 10V.
 
Bright 5mm LED CDI power on/off indicator with mounting bezel. (RED)
 
High reliability Surface Mount components reduce weight to only 0.6 oz and size to 1” x 1 ¾”.
 
Heavy duty 22 gauge twisted wire power extensions.
 

Have you seen ...

Katelyn Bedard Bone Marrow Association

TBOLT Squadron!





Copyright © 2022 Thunderbolt RC. Powered by Zen Cart