Categories

JETI CB200 SNAP-FIT Mount

  • Shipping Weight: 0.01lbs
  • Manufactured by: M.A.D. Fab

 Ask a Question 

$37.10CDN  $33.39CDN
Save: 10% off

(image for) Sold Out
With this design we wanted to allow for a clean and professional install, the CB200 is hard to mount and make it look good, without the Snap Fit Holder.  We even give you a place to run the power wires away from the CB200 and keep them clean as well.  The CB200 simply slides into the mount and then the cover is screwed into place and now you can remove the CB200 at will without having to undo Velcro, or get double sided tape off of your expensive piece of equipment.  The mount also provides great protection in case of a crash.

-Added protection for your expensive electronics
-Professional look
-Receiver is just as easy to remove with no sticky residue on it

This is the black High Temperature version.

Weight:

Mount with Lid = 19 grams

Mount with Receiver installed (Receiver not included).

Have you seen ...

(image for) Katelyn Bedard Bone Marrow Association

New Products  [more]

(image for) RV-8 60E G2 Super PNP - RED "NIGHT"
RV-8 60E G2 Super PNP - RED "NIGHT"
$1,302.24CDN  $949.99CDN
Save: 27% off

Currencies

TBOLT SQUADRON!





Copyright © 2024 Thunderbolt RC. Powered by Zen Cart