Categories

JETI R7/9/11 SNAP-FIT Mount

  • Shipping Weight: 0.01lbs
  • Manufactured by: M.A.D. Fab

 Ask a Question 

$23.75CDN  $21.38CDN
Save: 10% off

Add to Cart:
This holder allows for a clean install in any application.  The idea behind the design is to give you a clean and safe install and give you that professional touch.  The lid allows for a gyro mount or just to protect the receiver.  All the Jeti holders have built in servo plug protection as well.  This allows you to place your hot glue on the connections if you wish and then cover it up with the cover.  If your mounting in a gas airplane you can either just bolt it down or Velcro the mount in like you would normally, the nice part is that you can still remove the receiver at any time without having to peel Velcro or double stick tape off your expensive receivers!  These days 2.4 technology allows us to mount our receivers without needing foam like the old 72mhz days, and in fact most manufacturers tell you not to use foam because of the heat that 2.4 can create.  Our holders will not impede cooling of the receiver.

-Added protection for your expensive electronics
-Professional look
-Receiver simply "SNAPS" into place
-Receiver is just as easy to remove with no sticky residue on it
-When properly mounted the lid gives a great Gyro mounting platform
-You can stack the mounts for multi receiver set ups

This is the black High Temperature version.

Weight:

Mount with Lid = 9 grams

Mount with Receiver installed (Receiver not included).

Have you seen ...

(image for) Katelyn Bedard Bone Marrow Association

New Products  [more]

(image for) PowerBox Core PBR-14D Receiver
PowerBox Core PBR-14D Receiver
$352.89CDN  $317.60CDN
Save: 10% off

Currencies

TBOLT SQUADRON!





Copyright © 2024 Thunderbolt RC. Powered by Zen Cart